Make Your DIY Projects Much Easier
Features:
Stud scan:Locates the edges of wood and metal studs up 3/4 in(18mm)deep
Low battery indicate
Using the detector:
1. Position the unit flat against the wall.
2. Press on/off button and hold in.
3. Slowly slide unit horizontally across the wall, right or left. As you begin to approach a stud,the Yellow LEDs will light, from bottom to top.
4. When the top Red LED is light and the beep sound, you have located the edge of the stud.Mark this spot.
5. Continue scanning beyond the marked spot until the yellow LEDs go out. Slide unit in reverse direction to locate other edge of stud.
6. Mark this second spot. Between the two spots is the stud position.
INSTALLING THE BATTERY:
1.Squeeze sides of unit to help release clip end.
2.Slide 9V battery into compartment, terminal side first,matching(+)and(-)terminals from battery to case.
3.replace the clip.Battery life is approximately 50 hours.Low battery indicate:
The GREEN "READY"LED flashes when the battery level is getting low.
It's to power the tool for proper operation. Please replace the 9-volt battery with a brand new battery immediately.
net weight:67g
size:70*29*140mm
NOTES:
Sensing depth and accuracy can vary due to moisture, content or materials, wall texture,and paint.